- Installation time: Approx 10-minutes
Things you will need to install the CabTable™ in a Claas 500-900-series is:
1x Powerdrill
1x Torx 30 bit
1x Torx 20 bit
1x 10mm Wrench
1x Claas mounting bracket and CabTable™
Watch the mounting guide here:
Step 1 Remove Existing Bolts:
Start by unscrewing the 2 bolts highlighted in the picture. This is done with a torx 30.
Step 2 Mount the Bracket:
Position the mounting bracket so that its holes align with the 2 mounting points. Then, use a 10mm wrench to tighten the bolts securely.
Step 3 Attach the CabTable™:
Once the bracket is securely mounted, use a Torx 20 bit with a power drill to screw the table to the bracket through the four holes.
Step 4 Final Check:
Ensure all screws and bolts are tightened securely.
